PDB-XT60 W/ BEC 5V & 12V

  • Category: MATEK-PDB + REG
  • SKU: 6432




The PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36*50mm & 4 layers PCB.
It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronised & regulated DC 5V outputs & linear regulated
DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc.
It offers a XT60 socket to connect the LiPo pack conveniently

2oz copper, 4-layers &1.6mm PCB.Built-in XT60 SocketTotal 6 pairs ESC solder tabs are fit for H or X type frame 5V & 12V Output LED indicators & Short circuit tolerant.

General:- Input voltage range (3S-4S LiPo operation): 9 - 18V, DC- Regulated 5V and 12V outputs- LED power indicators ( 5V & 12V outputs )- 6 ESC outputs & 1 pair VCC/GND Pads ESC outputs:- Continuous current: 25A*4 or 15A*6- Peak current (10 seconds/minute): 30A*4 or 20A*6 BEC 5V output:- Designed for RC Receivers, Flight controllers, OSD, and Servos.- DC/DC synchronous buck regulator.- Voltage: 5.0 +/- 0.1VDC- Continuous current: 2 Amps (Max.2.5A 10s/minute)- Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)- Short-circuit tolerant (5 seconds/minute)BEC 12V output:- Designed for Video TX or FPV camera with linear regulator.- The battery should be 4S LiPo (13~18V DC)- Voltage: 12.0 +/- 0.3VDC- Continuous current: 500mA (Max.0.8A 5s/minute)- Short-circuit tolerant (2 seconds/minute)BEC 12V @ 3S LiPo- Output voltage= 3S LiPo voltage -1V Matek Manual Physical:- Dimensions: 36 x 50 x 4 mm (without XT60)- Mounting: 30.5 x 30.5mm, Φ3mm- Weight: 7.5g(w/o XT60), 11g(w/ XT60)

Matek Manual