DIATONE V8.3 LC Filter Power HUB

Out of stock
  • Category: MATEK-PDB + REG
  • SKU: 6452


Out of stock


Diatone V8.3 LC Filtered PDB Power Hub with 5V and 12V BEC

The Diatone V8.3 LC Filtered PDB Power Hub comes with some great features such as the ability to solder the ESCs onto either side of the PCB. The ESC solder pads have been redesigned from previous boards to make it easier solder on both X and H frames.

The 36x36mm size makes it easy to stack with the flight controller. 2 sets of BEC circuity provides 5V and 12V for using servos, video transmitters, LEDs, etc. Another new feature on the V8.3 board is the addition of an ESC signal channel for easy soldering and neat, compact wiring. The PDB supports 3~6S (11.1V~22.2V).

The new LC filter circuit uses a superior filter inductor and 47uf tantalum capacitor. With a 1A electrical load the 5V ripple is only just 31mV, the 12V ripple is only just 63mV. The camera and video transmitter now have a filtered power source.

 Look no further this is a PDB that needs to be in your order.

Features:• ESC can be soldered onto either side of PCB (tabs on both sides)
• 2oz copper and 4-layers PCB
• Low Ripple current
• ESC and Battery solder tabs in pairs
• Solder Bridges of 5V and 12V for Camera and VTX power
• DC/DC synchronous buck regulator, efficiency is up to 95%
• 5V and 12V Output LED indicators and short circuit tolerance

Working Voltage: 3~6S LiPoly (11.1-22.2V)
Output Voltage: 5V and 12V
Output Current: 2A
ESC outputs: 4
Current output: 4 x 20A
Size: 36 x 36mm
Weight: 5.5g
Mounting: 30.5mm / Φ3mm

Package included:
1 x Diatone V8.3 PDB
1 x Cable