GnarlyFPV Primo V080X Frame

Out of stock
  • SKU: 86602


Out of stock


The Primo, was designed to take the current 1S and 2S Brushless whoops guts, and plant them into a frame that pushes the limits of micro fpv. Designed to make the swap as simple and seamless as possible. I wanted something that could be swapped over in a matter of minutes, with no soldering required. The battery mounts are quick swappable, with 1 m2 screw. Swap from 1s to 2s is seconds. Frames are stout, at 2mm's thick However, as tough as the primo is, its not indestructible, so replacement frames will be available separately. Each kit will include all hardware needed for a brushless whoop swap. Just add your 1-2s whoop guts. Supports 16X16 stacks with optional canopy and stack mounts. Available in 080X and 110X flavors.

The 080X version does support 060X and 070X motors as well, as long as they have the same mounting pattern size. 



  • Primo 080X Frame
  • 65mm props
  • Jelly mount 
  • Canopy
  • 1S EZ swap mount 
  • 1S side by side EZ Swap mount
  • 2S (300mah-350mah )EZ swap mount
  • Hardware


  • Modula7
  • Eachine Trashcan
  • Beta65x  
  • Beta65Pro
  • Beta65Pro 2
  • Beta75Pro
  • Beta75Pro 2
  • UK65
  • US65
  • Snapper 6
  • Snapper 7
  • RakonHeli Whoops 
  • 080X, 070X, 060X motors


  • The Primo Canopy has been updated and will now support the EOS2 Camera, along with the Eachine trashcan VTX while also supporting the Mobula7 AIO Camera. Alternative AIO cameras should fit the canopy with the included camera mount as well. 
  • If using the older Betafpv double stacks, you'll have to raise the canopy higher to allow for clearance. M2 standoffs will work perfectly. 

Motor wire extensions available as an add on for betafpv motors, and or motors with shorter leads. 

Have your stack bound to your radio, before the transplant.