Lux V2 OSD Doge Stack

LUX V2

 32-bit Processor Flight Controller Support PPM or Serial RX For Multirotor Racing
1. Highest quality components
2. Micro USB connector for programming
3. Provides high quality flight control using the powerful F3 processor along with top of the line hardware
4. Supports PPM or Serial RX (including Futaba, FrSky, S.BUS). A signal inverter is already included for S.BUS.


Item name: Lux Flight Controller
PCB: Have
Weight: 6g
Output: 5v 1.0A
Input: Up to 26v (6S lipo)
RX Voltage Output Selectable: 3v/5v
Gyro/accelerometer: MPU6500 MEMS
Processor: STM32F303RCT6(256kB flash) 32-bit
Mode for bootloader + software: STM32 DFU
Dimensions: 36x36x6mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes

The OSDoge 

1 1/2 OSD is the perfect companion for F3 flight controllers that don't have OSD. Plug it in, flip the switch. Stack your Naze32 on top to add OSD, LC Filter, 5V and 12V clean power, and handy current/voltage sensor inputs.

• 12v and 5v clean power supplies for your FPV camera and VTX
• Onboard LC power filter
• Mini USB connector for direct connection to a computer
• Works with 3S and 4S batteries
• Plugs right into your F3! Stacks with 10mm standoffs, included

Item Packing

1x Lux V2 Flight Controller

1x Doge OSD  2x7 Straight Pin Headers