Version 2 Update:
The Pyrodrone F4 OSD has a new feature!
VTX Pit mode compatibility.
In order to use this feature jump the two pads with solder on the "PIT" side ( If this feature is not needed then just jump the pads of the "ON" side and your VTX will always be on)
After you jump the PIT pads connect to Betaflight and go to CLI page, type in the following commands:
resource PINIO 1 A14
set pinio_box = 39,0,0,0
type "save" and then hit enter.
Wait for the FC to reboot, then go to the "MODES" tab in Betaflight and set VTX PIT MODE to an AUX channel you prefer
This is the Hyperlite F4 OSD F4 Flight Controller. One of the most popular FC’s is back and better than ever, combining an industry favorite layout with new feature sets for freestyle, long range, and racers. Finally, a board for every pilot!
The new Hyperlite F4 OSD takes the same celebrated ‘flat-bottomed’ layout (crucial for clean and tight builds) and adds a much appreciated OSD and SIX UART ports (more than any other board on the market!) for GPS, RX, SmartAudio, and even Camera Control.
And with more features, comes improved ease of use with a built in 4-in-1 ESC socket and included harnesses for HobbyWing, AiKON AK32, and Spedix GS35 4in1 ESCs. The built in solder pads mirror the 4in1 pad layout, so you can easily connect ANY ESC to this board to get features like current sensing and ESC telemetry (for the BL32 guys).
PLEASE NOTE: The Hyperlite F4 OSD uses it’s own BF target .bin, “PYRODRONEF4”.
First batch customers.
The ESC to FC connection harnesses we received in this first batch have reversed pinout on the ESC side.
DO NOT CONNECT before fixing the pinout!
Please de-pin the esc side carefully using exacto knife or pair of fine tip tweezers, and swap the wires according to the following:
Aikon 4in1 ESC :
From left to right: PURPLE - YELLOW - BLUE - GREEN - BROWN - WHITE - EMPTY - RED - BLACK - EMPTY
Spedix GS35 4in1:
From Left to right: YELLOW - BLUE - GREEN - BROWN - WHITE - EMPTY - RED - BLACK - EMPTY
Hobby Wing Xrotor 40A 4in1 ESC:
Only the bigger connector needs to be fixed on the ESC side!
From Left to right: WHITE - BROWN - GREEN - BLUE - EMPTY - EMPTY