Talon GigaFusion Fusion F7 & Gigawatt V2 6S 35A ESC Combo


Out of stock
  • Category: ESC'S + 4IN1 + STACKS
  • SKU: 90210

Price:AU$135.10


Out of stock

Description

Our flagship Flight Controller is here and WOW! Using a dual gyro setup in 90° phase and a F7 processor will have your quad dialed in to the max! Pair it with our Talon Gigawatt 6S 35A ESC and you have a 20X20 6S powerhouse!


Specs

  1. MCU: STM32F722RET6 216MHz
  2. 2x ICM20602 GYROS 90 deg phase
  3. Built in Betaflight OSD
  4. Up to 8S (36V) direct battery power
  5. Buzzer pads for external buzzer
  6. Built in voltage monitoring resistor
  7. 5V 2A BEC
  8. Dedicated LDO for Gyro, noise free gyro power
  9. Dedicated LDO for OSD, cleaner OSD signal
  10. Led strip shares 5V with 5V/2A BEC
  11. 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
  12. Built in camera control pin with resistor and capacitor
  13. 5 Full UARTS with RX AND TX pins
  14. Logical pin layout for cleanest build possible
  15. 8 pin 4 IN 1 ESC plug
  16. Remapable LED pad for additional motor output
  17. TX3, RX3 can be used for I2C for external compass
  18. 5V, VBAT selectable VTX and CAM power
  19. 16M Blackbox flash chip
  20. No flicker VTX pit mode switch (positive switch)
  21. M4 Can be selected either led_strip signal or M4 signal for RPM filtering

20 X 20 mounting hole with true 25mm board dimensions

To get Motor 4 to work please use the CLI command below using Betaflight V4.0.4. A custom hex is coming soon for 4.0.4.

Resource MOTOR 6

 None


Resource MOTOR 4 C08


Save


To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit


Setting up Pit Mode:



TOP LAYOUT

BOTTOM LAYOUT

Looking for the perfect 6S companion for your Talon FC? Good news! The Talon Gigawatt V2 has arrived! 

The Talon Gigawatt V2 4-in-1 35A 6S is a new generation ESC that uses a variety of bleeding edge technologies in hardware and firmware.


The Talon Gigawatt is worth your investment.


BLHeli_32 code base

Programmable PWM frequency of up to 48KHz

Auto-timing for higher efficiency and reliability

Analog Voltage/Current sensing

Adjustable “Brake on Stop” force

Improve direction change in Bidirectional mode

One current sensor to measure the total amp draw and telemetry functions.

ESC Telemetry (Voltage and RPMs and current)

Configuring from FC using DShot commands

Programmable sine modulation mode

Programmable soft bidirectional mode

Programmable autonomous periodic (every 32ms) telemetry mode

Hardware noise filter on the signal input

New Aluminum Heat shield to help dissipate heat


SPECIFICATIONS


Battery2-6s
Constant Current35A
Burst Current45A
Mount Hole20*20mm
FirmwareBLHeli32
MCUSTM32PINF0
BootloaderYes
Weight( with/wire)10g
Signal wire length100mm
Battery wire length100m