*New technology coating elliptical body
*High-strength 5mm Titanium alloy shaft
*7075 aluminum Bell and Base
*Electromagnetically matched magnets and stator
*Japanese NSK bearings
*N52H Arc curve magnets
*Motor wires protected
*Dynamically balanced
Specification
- Model: XING 1408
- KV: 3600KV
- Version: CW Screw Thread
- Input Voltage: 2-4S Lipo
- Configuration: 9N12P
- Stator Diameter: 14mm
- Stator Length: 8mm
- Dimension: 18.2×31.5mm
- Weight: 16.3g with short wire
SPECS:
- Processor: STM32F446RET6, Coretx-M4, 32bit, 180MHz, 128kB RAM, 512kB Flash.
- IMU: Bosch Sensortec BMI160 running at 3.2kHz, connected using SPI.
- OSD: Full-graphic, PAL/NTSC auto detect, adjustable black and white levels. Full Betaflight OSD support with extra graphical features. Support for side-by-side 3D when used with a 3D FPV camera.
- Motor Outputs: 6 outputs with full DSHOT (150/300/600/1200) and OneShot support.
- Receiver Support: PPM, S.Bus (inverter built-in), DSM, HoTT, SRXL, CSRF, FPort ready. 5V or 3.3V supply for receiver. Receiver is powered from USB for easy and safe setup.
- Telemetry Support: FrSKY Smart Port, FrSKY Sensor Hub, HoTT Telemetry, SRXL, CSRF, FPort ready. Built-in inverter for FrSKY telemetry.
- Serial Ports: 4 full serial ports (UARTs). UART3 and UART6 have inverters for S.Bus and SmartPort telemetry. Inverters are automatically enabled/disabled for maximum flexibility.
- RGB LEDs: Dedicated RGB LED output.
- Camera Control: Dedicated output for accessing the camera menu to change camera settings.
- Buzzer Port: Dedicated port for 5V (100mA max) buzzers.
- Analog Inputs: Voltage sensing (VBAT), current input (3.3V max).
- Power: 3S - 6S (7.5V - 26V), 500mA BEC
- Dimensions: 26.5mm x 26.5mm, 20mm hole spacing. 4.1mm holes for anti-vibration grommets for M3 screws.
- Weight: 4g
- Gluten free, Non GMO, Free Range Anorganic Gyro
SPECS
BATTERY 2-6S
CONSTANT CURRENT 35A
BURST CURRENT 45A
MOUNT HOLE 20x20
FIRMWARE BLHELI 32
MCU STM32PINF0
BOOTLOADER YES
WEIGHT 10G